2.11 Toolbox Documentation Return to Table of Contents

Configuration Program
Sets coverages to be used with the 2.11 Toolbox
Configure Menu

Before you run the 2.11 Toolbox for the first time, you must tell the system which coverages to work with. Although this can be done by editing the configuration file coverages.dat, found in your working directory, it is easier to run the configuration program. This is done by typing &r configure at the Arc: prompt.

The Configure Menu will appear. You can type the name of each coverage into the menu fields, or, by using the Popup button, you can select coverages from a menu.

Tip: If you do not wish to use a Geographic or Cutlines coverage, you can leave these entries blank.

When the coverages are set correctly, click on Dismiss Button to quit the Configuration Program.


Table of Contents | Go Back | Back to Home Page